How to deal with the dirt on the LCD splicing screen?

In the face of high-tech seamless LCD splicing screen, do you suffer from the lack of maintenance and miss its companionship? Will you be upset because you are not familiar with maintenance? Don't worry, Xiaobian provides you with maintenance tips.

1. Intermittent rest:

LCD seamlessly splicing large screens can easily overheat some pixels due to long hours of work. Once the upper limit is exceeded, permanent damage will occur, which forms a common "bad point". Since the liquid crystal seamlessly splicing the pixels of the large screen is composed of liquid crystals, when it is continuously operated at full load for more than 96 hours, it will accelerate its aging, and even burn out when it is severe. Therefore, if the user has to work for a long time, try to pause it for a while, or change the screen display content at different time intervals, because the brightness is reduced while waiting for work, or it is in screen saver mode. After a while, this can not only delay the aging of the LCD screen, but also avoid hardware damage.

2, find someone to repair:

There is a problem with the LCD splicing large screen. It is forbidden to assemble the LCD splicing large screen by yourself (especially for those who are interested in general DIY). Once the LCD seamlessly splicing the large screen is not working properly, you can find the manufacturer to help solve it. Since the transformer in the LCD backlight assembly may still have a 1000V high voltage (albeit a micro-current) after a certain period of shutdown, non-professionals may cause new component failure if not handled properly.

3. Reduce collisions:

The LCD display screen is very fragile and has a low impact resistance. This is because the LCD contains many precision glass components and agile electrical components that can cause damage to the LCD screen and other related components in the event of a strong impact. So be sure to avoid strong shocks. At the same time, it is also important not to put pressure on the surface of the LCD screen, such as pointing a finger to a certain part of the screen, which easily causes the increase of dead pixels.

4. Correctly handle dirt:

Once the surface of the LCD screen is found to be dirty, the dirt should be removed using an accurate method. Use a medium that is as soft or non-fibrous as possible, such as absorbent cotton, lens paper, or soft cloth, and then gently wipe it off with a little glass cleaner. Do not use chemical solutions such as alcohol or rough. Cloth or paper items, because such materials are prone to scratches. It is important to remind everyone that the cleaning should not be sprayed directly onto the surface of the display screen. It easily flows into the screen and causes short-circuit faults inside the LCD screen, causing unnecessary losses.