In the case of running mill, the slurry is discharged from the equipment if it does not meet the requirements. The reasons are as follows: the amount of equipment supplied is too large beyond the capacity of the ball mill, causing the equipment to run out of the slurry. It is recommended to reduce and stabilize the cementing of the cement ball mill and the ratio of return to minerals should be appropriately reduced.
The reason why the blockage occurs is because of the fact that the solidification of the slurry in the equipment is not smooth and the slurry can not be discharged smoothly. At this time, the feedstock should be stopped first to increase the solidification ratio of the slurry, which can facilitate the discharge of the slurry. . In the process of making the slurry, excessive mixing of the raw material lime causes adhesion to the wall of the cylinder, which may cause clogging due to difficulty in the abrasive. If the clogging is to stop the feeding, the high-pressure water gun is used to fill the raw material adhered to the wall of the cylinder. The cement ball mill equipment can be operated normally. Moreover, the width of the sieve plate is the cause of blockage of the particles. When the ore is clogged on the sieve plate, the equipment is stopped to clean the ore, and the width of the sieve plate is adjusted to ensure the normal operation of the equipment.
In the case of running or blocking, you can solve the situation of the equipment according to the above processing method. I hope the above analysis can help you.
Air Fryer Home Use,Cheap Air Fryer,Digital Air Fryer,Commercial Air Fryer
Yiwu Waterfilter Industry And Trade Co.,ltd , https://www.aqua-water-filter.com