Zhengzhou Dingli Drying Equipment Co., Ltd. is a professional manufacturer of slime drying equipment. Telephone, 67819598. Slime drying process is as follows: Since the slime has a certain viscosity, the wet slime enters the drying equipment during the drying process and is divided into the following working areas: First, the material guiding zone, wet coal slime enters this zone and rapidly evaporates in contact with high temperature hot air. Moisture and material are transferred to the next working area under the guidance of the large-angled copying board. The second is the cleaning area where the wet slime is copied by the copying board to form the material curtain, and the material falls. Easy to form the phenomenon of sticking drum wall, in this area due to the device design has a cleaning device, the cleaning device is very reasonably cleaned the material adhered to the inner wall, in this process, the cleaning device also plays a broken role for the agglomeration of the material ball. As a result, the heat exchange area is increased and the drying rate is increased. Third, the inclined plate raising area is in which the wet slime has been in a state of low moisture looseness, and the material has not been bonded in this area. After heat exchange, the material reaches The required moisture state enters the final discharge zone. The fourth is the discharge zone. The roller does not have a copy board in this zone. The material is rolling in the zone to the discharge port to complete the entire drying process. At present, the equipment has been put into use in a number of slime washing enterprises in Henan, Anhui, Heilongjiang and Guizhou, and has created considerable economic benefits. Website: http://
Slurry Pump,Slurry Pump Parts ,Sand Gravel Pump Co., Ltd. , http://www.hbslurrypumps.com